yo scotty its ray again the guy with the 01 Saturn sc2 i asked you y my coolant was boiling in the car. {broken temp censer} But my question now is their any thing ells that could cause the clutch to only grab at the back end of the peddle other than me have to drop the tranie and replacing the clutch and throw out barring. Because i dont have a lift or even 2 floor jacks hear to do it with i am hoping that it could be caused by something ells like a bad master or slave cylinder but every where i asked and look they just say the same thing the clutch it self is just worn and need to be replaced and i relay dont think i can do that hear my self safely. With out at the vary lest buy another floor jack to raze and lower the tranie out and back in hear at home any advise Btw the car passed your leek down test on the head gasket just fine but i did figure out that the piston rings on 3 and 1 are going bad their not horrible yet but ya so theirs job to look forward to lol.

Comments
No. 1-2
hellsdog1912
hellsdog1912

yay yeppy for me so well f it if i got to drop the tranie anyway i am upgrading to a stage 2 since i am in their any way and a new throw out barring because every one says you have to replace it wen you replace your clutch. i dont get y but i guess wail i am at it. on the note y dose everyone say you need to replace your throw out barring any way? are they matched to the clutch plates and presser plates?

ScottyKilmer
ScottyKilmer

clutch is just worn, live with it until it starts slipping, then time for a new one. NOT a fun job, I've done Saturns before and they are poorly designed for clutch swaps

Stories