Project Taurus

This car was given to me by my Mother so I'm going to keep it as asked. Few things I need to fix with your help?

So the intake manifold runner needed to be replaced, but the screws broke off on the back bracket, while replacing them. So I tried to extract the the screw but the cheap bit broke off too, I know, I know not good so now I'm here. Pictures to show, a shop said they could get them out, but is there a cheaper way?

Comments
No. 1-3
ScottyKilmer
ScottyKilmer

Editor

you could try using JB weld Kwik epoxy to epoxy them in place and seal them

Jamessymens
Jamessymens

Jamessymens
Jamessymens

Stories