I have an 08 honda accord that has a clunking noise when i stop and take off. I have replaced upper…

HondaHelpNeeded

I have an 08 honda accord that has a clunking noise when i stop and take off. I have replaced upper and lower control arms, brakes, brake caliper and tie rods. When i jack up car to replace something it takes about 10 minutes for the noise to come back. Im lost, please help!

Comments (8)
No. 1-8
Paul Ng
Paul Ng

Try using a pneumatic impact hammer with a tapered chisel point in the center of the shaft. Works for me every time. Using a hammer may mushroom out your shaft and you'll never get it out.

HondaHelpNeeded
HondaHelpNeeded

Cv axle stuck in hub, any thoughts on getting it out? Hammer not working

HondaHelpNeeded
HondaHelpNeeded

Ok thanks for your help!

ScottyKilmer
ScottyKilmer

yes,replace it then

HondaHelpNeeded
HondaHelpNeeded

Its worn, it goes in all directions and makes a cling noise.

ScottyKilmer
ScottyKilmer

you can test the ball joint by pressing down on the lower a frame with a long pray bar with it jacked up to check for wear

HondaHelpNeeded
HondaHelpNeeded

Will look into that. Any thoughts on it being the lower ball joint? Dealership said they though that may be the problem.

ScottyKilmer
ScottyKilmer

check or worn motor and transmission mounts on one that old.